Digi ConnectPort Network Device Podręcznik Użytkownika Pobierz pdf (Strona 128)

128

Using the Reset button

If the ConnectPort LTS device cannot be accessed from the web interface, the configuration can be

restored to factory defaults by using the Reset button. In this case, all current settings including the

IP settings will be cleared.

Reset ConnectPort LTS

1. Locate the Factory Reset button on the front of device, as shown in the figure. Use a non-

conducive, small diameter tool (such as wood or plastic) with a blunt end (NOT SHARP or the

button could be damaged) to press gently.

2. Hold down the reset button about 2~3 seconds and then release it.

3. Check the status of Ready LED. When the restoration is complete, Ready LED will be turn on

again.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 148 149

Brak uwag

Digi ConnectPort Network Device Podręcznik Użytkownika Strona 128