Digi M10 Technical overview and Przewodnik Instalacji Pobierz pdf (Strona 48)

Chapter 5: Installing the Power Strip, PSUs, Switches, and Cables 43

4 Locate the power cables included in each PSU box, as well as those included in the Bolster package.

5 Connect the appropriate end of the power cables from the Bolster package to the PSU (repeat for all PSUs).

6 Feed the other end of the AC cables through the opening in each Back Tie Plate and run them through the upper (square) cable

guide openings in the Rear Panel as shown in Figure 15.

7 Plug each PSUs AC cable into an available socket on the Power Strip you installed at the beginning of this chapter.

Reconnect the Power Cable Harness to Each Chassis

After all Ethernet and PSU power cables are installed, reconnect each power harness to its chassis power terminals as shown in

Figure 16.

Figure 15. Feeding the cable through the Back Tie Plate and connecting it to the PSU (Ethernet switch not shown)

Figure 16. Reconnecting Power harness (switch and PSUs not shown)

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 81 82

Brak uwag

Digi M10 Technical overview and Przewodnik Instalacji Strona 48